The CogFindCircle type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
 | CaliperProjectionLength | The length of each caliper region along the caliper projection direction. Specified in units of the selected space of the input image. |
| CaliperRunParams | Parameters used to run the calipers. |
| CaliperSearchDirection | Indicates whether each caliper should search inward towards the center of the Circle, or outward away from the center of the Circle. |
| CaliperSearchLength | The length of each caliper region along the caliper search direction. Specified in units of the selected space of the input image. |
| ChangedEventSuspended | If nonzero, indicates that the raising of the Changed event has been suspended. This value is incremented when SuspendChangedEvent is called and decremented when ResumeAndRaiseChangedEvent is called. |
| DecrementNumToIgnore | If DecrementNumToIgnore is true then the number of points ignored is actually (NumToIgnore - Number of calipers that found no edge). |
| ExpectedCircularArc | The expected CircularArc which is used to position the calipers for finding the Circle. |
| HasChanged | If true, the serializable state of this object has changed since the last time it was serialized. |
| NumCalipers | Number of calipers used to find the Circle. NumCalipers - NumToIgnore must be greater than or equal to the minimum number of points required to find the shape. For example, minimum points for a line = 2, circle = 3, & ellipse = 5. |
| NumToIgnore | The number of points that will be ignored in the fitting operation. If DecrementNumToIgnore is true then the number of points ignored is actually (NumToIgnore - Number of calipers that found no edge). |
| RadiusConstraint | The value that the radius of the circle will be constrained to if radius is constrained. |
| RadiusConstraintEnabled | Whether radius will be constrained for the fit. |
See Also