Enable creation of records by bitwise ORing the appropriate LastRunRecordDiagConstants. These are diagnostic records that may cause the Tool to have a longer execution time.
Namespace: Cognex.VisionPro.DimensioningAssembly: Cognex.VisionPro.Dimensioning (in Cognex.VisionPro.Dimensioning.dll) Version: 65.1.0.0
public CogIntersectLineEllipseLastRunRecordDiagConstants LastRunRecordDiagEnable { get; set; }public CogIntersectLineEllipseLastRunRecordDiagConstants LastRunRecordDiagEnable { get; set; }Public Property LastRunRecordDiagEnable As CogIntersectLineEllipseLastRunRecordDiagConstants
Get
Set
Public Property LastRunRecordDiagEnable As CogIntersectLineEllipseLastRunRecordDiagConstants
Get
Set
public:
property CogIntersectLineEllipseLastRunRecordDiagConstants LastRunRecordDiagEnable {
CogIntersectLineEllipseLastRunRecordDiagConstants get ();
void set (CogIntersectLineEllipseLastRunRecordDiagConstants value);
}public:
property CogIntersectLineEllipseLastRunRecordDiagConstants LastRunRecordDiagEnable {
CogIntersectLineEllipseLastRunRecordDiagConstants get ();
void set (CogIntersectLineEllipseLastRunRecordDiagConstants value);
}Property Value
Type:
CogIntersectLineEllipseLastRunRecordDiagConstantsThis property is part of a tool wrapper for
CogMath.IntersectLineEllipse(CogLine, CogEllipse, ICogImage, Int32 , Double , Double , Double , Double )
so that you can use it in QuickBuild.
If you want to use IntersectLineEllipse(CogLine, CogEllipse, ICogImage, Int32 , Double , Double , Double , Double )
in your application, you should use it directly.
If you are using QuickBuild, you should use the
CogIntersectLineEllipseTool control
in the QuickBuild's Job Editor toolbox.
There is virtually no case in which you should use this property
or any part of CogIntersectLineEllipseTool directly in your application.
Enable creation of records by bitwise ORing the appropriate LastRunRecordDiagConstants. These are diagnostic records that may cause the Tool to have a longer execution time.