Gets the tolerance object for the angle.

If nonzero, indicates that the raising of the Changed event has been suspended. This value is incremented when SuspendChangedEvent is called and decremented when ResumeAndRaiseChangedEvent is called.

Gets or sets the CombineGraphicsEnabled. When true, the combined graphics will be displayed in the last run record. Combined graphics usually are the features or measurements produced by an operator.

Gets the Cog3DRangeImageCrossSectionTolerance object to tolerance the EndX position.

Gets the Cog3DRangeImageCrossSectionTolerance object to tolerance the EndY position.

If the operator produces a feature, the feature is returned in the range image SelectedSpaceName stored in the profile. The FeatureInImage is available after the operator was run. The FeatureInImage is set to null at the beginning of the tool run.

If the operator produces a feature, the feature is returned in the range image SelectedSpaceName3D stored in the profile. The FeatureInImage3D is available after the operator was run. The FeatureInImage3D is set to null at the beginning of the tool run.

Cognex Internal Use Only.

Gets or sets the InputGraphicsEnabled. When true, the input graphics will be displayed in the current record. Input graphics usually are the regions.

Gets the line segment extracted by the execute method. Always check the status of the operator to be either Passed or FailedTolerance before calling the getter.

Gets the line segment extracted by the execute method.

Gets the line segment extracted by the execute method.

Gets or sets the name of the operator. When the operator is within a collection, the name is checked for uniqueness.

Gets or sets the OutputGraphicsEnabled. When true, the output graphics will be displayed in the current record. Output graphics usually are the features or measurements produced by an operator.

Gets the OutputType of the operator.

Gets the Regions. The regions property is a collection of ICogRegion.

Gets the ResultObject of the operator. The ResultObject is available after the operator was run. The ResultObject is set to null at the beginning of the tool run.

Gets the RMS error of the line segment.

Gets the tolerance object for the RMS error.

Cognex Internal Use Only.

Gets the Cog3DRangeImageCrossSectionTolerance object to tolerance the StartX position.

Gets the Cog3DRangeImageCrossSectionTolerance object to tolerance the StartY position.

Returns the complete set of state flags supported on this object. The flags may be indexed by name as shown in the following C# code snippet: if (changedObject.StateFlags["Color"] & eventArgs.StateFlags) { ... }

Gets the status.

Gets the ToleranceCollection. The ToleranceCollection is initialiazed by the operator and the user will not be able to delete or add to it. Each operator adds a pre-defined set based on the operator result object. By default, all tolerances are disabled.

Gets the Tolerance object of an item specified by name. if name is not found, the return is null.