Enable creation of records by bitwise ORing the appropriate LastRunRecordDiagConstants. These are diagnostic records that may cause the Tool to have a longer execution time.
Namespace: Cognex.VisionPro.DimensioningAssembly: Cognex.VisionPro.Dimensioning (in Cognex.VisionPro.Dimensioning.dll) Version: 65.1.0.0
public CogIntersectLineCircleLastRunRecordDiagConstants LastRunRecordDiagEnable { get; set; }public CogIntersectLineCircleLastRunRecordDiagConstants LastRunRecordDiagEnable { get; set; }Public Property LastRunRecordDiagEnable As CogIntersectLineCircleLastRunRecordDiagConstants
Get
Set
Public Property LastRunRecordDiagEnable As CogIntersectLineCircleLastRunRecordDiagConstants
Get
Set
public:
property CogIntersectLineCircleLastRunRecordDiagConstants LastRunRecordDiagEnable {
CogIntersectLineCircleLastRunRecordDiagConstants get ();
void set (CogIntersectLineCircleLastRunRecordDiagConstants value);
}public:
property CogIntersectLineCircleLastRunRecordDiagConstants LastRunRecordDiagEnable {
CogIntersectLineCircleLastRunRecordDiagConstants get ();
void set (CogIntersectLineCircleLastRunRecordDiagConstants value);
}Property Value
Type:
CogIntersectLineCircleLastRunRecordDiagConstantsThis property is part of a tool wrapper for
CogMath.IntersectLineCircle(CogLine, CogCircle, ICogImage, Int32 , Double , Double , Double , Double )
so that you can use it in QuickBuild.
If you want to use IntersectLineCircle(CogLine, CogCircle, ICogImage, Int32 , Double , Double , Double , Double )
in your application, you should use it directly.
If you are using QuickBuild, you should use the
CogIntersectLineCircleTool control
in the QuickBuild's Job Editor toolbox.
There is virtually no case in which you should use this property
or any part of CogIntersectLineCircleTool directly in your application.
Enable creation of records by bitwise ORing the appropriate LastRunRecordDiagConstants. These are diagnostic records that may cause the Tool to have a longer execution time.