Cog3DRangeImageCrossSectionAngleLineLine.Execute Method

Cog3DRangeImageCrossSectionAngleLineLine Execute Method

Cognex VisionPro

Computes the angle between the lines that extend from the two line segments.

Namespace: Cognex.VisionPro3D
Assembly: Cognex.VisionPro3D (in Cognex.VisionPro3D.dll) Version: 65.1.0.0

Syntax

public override void Execute(
	Cog3DRangeImageCrossSectionProfile profile
)

public override void Execute(
	Cog3DRangeImageCrossSectionProfile profile
)

Public Overrides Sub Execute ( 
	profile As Cog3DRangeImageCrossSectionProfile
)

Public Overrides Sub Execute ( 
	profile As Cog3DRangeImageCrossSectionProfile
)

public:
virtual void Execute(
	Cog3DRangeImageCrossSectionProfile^ profile
) override

public:
virtual void Execute(
	Cog3DRangeImageCrossSectionProfile^ profile
) override

profile: Type: Cognex.VisionPro3D Cog3DRangeImageCrossSectionProfile
The angle is computed in the profile selected space name.

Events

Event Type	Reason
Cognex.VisionPro ICogChangedEvent	Fires when this method is called. The following state flag may be affected: SfStatus SfAngle

Event Type

Reason

Fires when this method is called.

The following state flag may be affected:

Exceptions

Exception	Condition
CogSecurityViolationException	If licensing for this class cannot be confirmed.
ArgumentNullException	If the operator is not in a collection.

Remarks

The status returned can be one of the following:

The angle was computed successfully and passed any enabled tolerance checking. Passed
The angle was computed successfully but failed tolerance checking. FailedTolerance
The operator failed. FailedToMeasure
The line segment(s) was/were not found in the collection at run time. InputFeatureMissing