Cog3DCylinderFitterUsing2DPoints.FitMode Property

Cog3DCylinderFitterUsing2DPoints FitMode Property

Cognex VisionPro 9.23

Gets/sets the fit mode for 3D cylinder fitting.

Namespace: Cognex.VisionPro3D
Assembly: Cognex.VisionPro3D (in Cognex.VisionPro3D.dll) Version: 91.0.0.0

Syntax

public virtual Cog3DCylinderFitterUsing2DPointsFitModeConstants FitMode { get; set; }

public virtual Cog3DCylinderFitterUsing2DPointsFitModeConstants FitMode { get; set; }

Public Overridable Property FitMode As Cog3DCylinderFitterUsing2DPointsFitModeConstants 
	Get 
	Set

Public Overridable Property FitMode As Cog3DCylinderFitterUsing2DPointsFitModeConstants 
	Get 
	Set

public:
virtual property Cog3DCylinderFitterUsing2DPointsFitModeConstants FitMode {
	Cog3DCylinderFitterUsing2DPointsFitModeConstants get ();
	void set (Cog3DCylinderFitterUsing2DPointsFitModeConstants value);
}

public:
virtual property Cog3DCylinderFitterUsing2DPointsFitModeConstants FitMode {
	Cog3DCylinderFitterUsing2DPointsFitModeConstants get ();
	void set (Cog3DCylinderFitterUsing2DPointsFitModeConstants value);
}

Property Value

Type: Cog3DCylinderFitterUsing2DPointsFitModeConstants
The fit mode for cylinder fitting.

Exceptions

Exception	Condition
ArgumentException	If an invalid fit mode is used in the setter.

Remarks

If FitMode is Cog3DCylinderFitterUsing2DPointsFitModeConstants.eLeastSquaresUseSpecifiedRadiusAndHeight, then Execute() will use the values of Radius and Height . If FitMode is Cog3DCylinderFitterUsing2DPointsFitModeConstants.eLeastSquaresComputeRadiusAndHeight, then Execute() will ignore the values of Radius and Height.