Gets or sets the maximum absolute amount an edge position can deviate from a trained edge position. It is specified as a fraction of the average bead width.

If nonzero, indicates that the raising of the Changed event has been suspended. This value is incremented when SuspendChangedEvent is called and decremented when ResumeAndRaiseChangedEvent is called.

Gets or sets the minimum number of consecutive failing calipers for a defect to be reported. Indirectly this property determines the length (along the bead) of the smallest reported defect.

Gets or sets the minimum contrast required for detecting the edges of the bead.

Gets or sets the maximum acceptable coverage, any coverage above this value can be a defect.

Gets or sets a flag to indicate whether the CoverageMax tolerance is enabled. If true, CoverageMax will be used at runtime to report defects of type Overfill.

Gets or sets the minimum acceptable coverage, any coverage below this value can be a defect.

Gets or sets a flag to indicate whether the CoverageMin tolerance is enabled. If true, CoverageMin will be used at runtime to report defects of type Underfill.

Gets an ICogBoolList whose Boolean elements indicate which calipers along the trained bead path should insert a "fill edge" if no edge is found on the left side (relative to the path direction) of the bead at runtime.

Gets an ICogBoolList whose Boolean elements indicate which calipers along the trained bead path should be ignored at runtime when searching for defects.

Gets an ICogBoolList whose Boolean elements indicate which calipers along the trained bead path should insert a "fill edge" if no edge is found on the right side (relative to the path direction) of the bead at runtime.

Returns the complete set of state flags supported on this object. The flags may be indexed by name as shown in the following C# code snippet: if (changedObject.StateFlags["Color"] & eventArgs.StateFlags) { ... }

Gets or sets the maximum relative amount an edge position can deviate from neighboring edges. It is specified as a fraction of average bead width at that location. A low value means a closer match and a high value means more tolerance.

Gets or sets a flag to indicate whether the StepThreshold tolerance is enabled. If true, StepThreshold will be used at runtime to report defects of type AboveStepThreshold.

Gets or sets the maximum acceptable width ratio, any ratio above this value can be a defect. The ratio is computed using the bead width at runtime to the average bead width at train time.

Gets or sets a flag to indicate whether the WidthMax tolerance is enabled. If true, WidthMax will be used at runtime to report defects of type TooWide.

Gets or sets the minimum acceptable width ratio, any ratio below this value can be a defect. The ratio is computed using the bead width at runtime to the average width at train time.

Gets or sets a flag to indicate whether the WidthMin tolerance is enabled. If true, WidthMin will be used at runtime to report defects of type TooNarrow.