CogCADFile.SplineApproximationSpacing Property

CogCADFile SplineApproximationSpacing Property

Cognex VisionPro 9.10

All splines in the CAD file will be approximated. Sample points are computed along the spline such that the arc lengths between adjacent sample points do not exceed this spacing. This spacing value is in the the same units as the CAD file.

Namespace: Cognex.VisionPro
Assembly: Cognex.VisionPro.Core (in Cognex.VisionPro.Core.dll) Version: 79.0.0.0

Syntax

C++

Copy to Clipboard Print

public double SplineApproximationSpacing { get; set; }

public double SplineApproximationSpacing { get; set; }

Public Property SplineApproximationSpacing As Double 
	Get 
	Set

Public Property SplineApproximationSpacing As Double 
	Get 
	Set

public:
property double SplineApproximationSpacing {
	double get ();
	void set (double value);
}

public:
property double SplineApproximationSpacing {
	double get ();
	void set (double value);
}

Property Value

Type: Double

Events

Event Type	Reason
CogCADFile Changed	Fires when this property changes. The following state flag may be affected:

Event Type

Reason

CogCADFile Changed

Fires when this property changes.

The following state flag may be affected:

Exceptions

Exception	Condition
ArgumentException	A value less than or equal to 0 was supplied.

Remarks

All splines in the CAD file will be approximated. Sample points are computed along the spline such that the arc lengths between adjacent sample points do not exceed this spacing. This value is specified in the units of the CAD file's coordinate system.

Default Value: 1.0