Measure Radius Measurement Tool - Range Limits Tab

Defines the maximum acceptable radius value; the tool will create a Smart Limit default setting based on your image, which you can customize to suit the needs of your application.

Reports the current measured radius of the found curved edge feature; values that fall exactly at, or between, the Minimum and Maximum settings are classified as a Pass.

Note: The tool reports results in pixels, unless the image was calibrated to real-world units in Set Up Image.

Defines the minimum acceptable radius value; the tool will create a Smart Limit default setting based on your image, which you can customize to suit the needs of your application.

Defines whether or not the Pass/Fail logic of the tool should be inverted (default = Off, unchecked):

  • Unchecked - Standard results are applied, i.e. the tool result is a Pass if the feature was detected and falls within the specified settings.
  • Checked - Inverts the results, i.e. the tool result is a Fail if the feature was detected and falls within the specified settings.

Defines the limits based on the Smart Limits settings. This button is useful when a parameter has been changed and the limits need to be adjusted, or the tool has been added and no limits have been defined.