Edge Defect Detection Tool - Fit Tab
When the Fit tab is selected, the tool will display all of the found edge candidates within the region and the best-fit circle or line result. The edge candidates represent the possible edges to be considered when constructing the best-fit circle and line, and edge candidates are indicated by small, color coded circles.
The region may also be selected and adjusted when in this tab.
Filter Outliers
Defines whether or not the tool will remove points from the best-fit line that are further than the distance defined by the Fit Distance Filter parameter (by default, this parameter is enabled).
Fit Distance Filter
Defines the distance (1 - 1920; default = 2), in pixels, from which an edge must be from the original best-fit line to be utilized in a re-fit calculation. This parameter is helpful in preventing defects from affecting the line fit.
Furthest Point Filter Distance
Defines the outlier distance (1 - 1920; default = 1000) beyond which edges are not used to determine the minimum and maximum distances; any edge which is greater than this value will be ignored.
Re-Score
Defines whether or not the detected edges will be re-scored to ensure that detected edges that were initially discarded were filtered correctly (by default, this parameter is enabled).
Re-Fit
Defines whether or not the tool will re-fit the best-fit line after the edges have been re-scored (by default, this parameter is enabled).