Connecting the Power and I/O Breakout Cable

CAUTION:  To reduce emissions, connect the far end of the Breakout cable shield to frame ground.
Note:
  • Perform wiring or adjustments to I/O devices when the vision system is not receiving power.
  • You can clip unused wires short or use a tie made of non-conductive material to tie them back. Keep bare wires separated from the +24 V DC wire.
  1. Verify that the 24 V DC power supply is unplugged and not receiving power.

  2. Attach the +24 V DC connector of the Power and I/O Breakout cable and Ground wires to the corresponding terminals on the power supply. For more information, see Specifications.

  3. Attach the M12 connector of the Power and I/O Breakout Cable to the 24 V DC connector of the vision system.

  4. Restore power to the 24 V DC power supply and turn it on if necessary.